 |
| |
Submersible Pump
...................................................................................... |
|
| |
Oil Mist Collector
|
|
|
|
| |
|
|
|
Buku Panduan 1
(pdf) |
|
|
|
|
|
|
|
|
|
|
|
 BM -
Oil Mist Collector
The
Largest Submersible Pump Manufacturer in Taiwan
● BM Oil Mist Ducted style 
● Clean the Air
● Machine Fluid Savings
● Most of Oil is separated, not filtered
● Reduced Mist Exposure
● No expensive filters to replace
● Reduces Housekeeping Costs
● Easy installation & maintenance
● Compact and light weight.
............................................................................................................................................................ |
|
|
BV
(Oil Mist Collector)
●
BV Oil Mist Direct Mount style
● Clean the Air
● Machine Fluid Savings
● Most of Oil is separated, not filtered
● Reduced Mist Exposure
● No expensive filters to replace
● Reduces Housekeeping Costs
● Easy installation & maintenance
● Compact and light weight.
......................................................................
|
|
|
|
APPLICATIONS
► ►CNC Lathe, NC
Processing, Spray coating machine, Tapping machine, Machine Center,
Homing Machine
|
|
HOW THE OIL MIST IS
COLLECTED
1. Pre-separation
The oil mist is sucked away from the tooling area of the machining
tool through the 4 inch intake. The primary "stainless pleated
cartridge" separates most of the oil mist and provides exceptional
gravity drainage. The bulk of the oil is quickly removed out of the
air flow and to be drained back to the machine tool through the 4
inch intake (BV type) or the 1/2 inch oil pipe drain (BM type).
2. Centrifugal
In the intermediate blower, a vortex is created by the fan rotation
causing a formation of large oil drops which will easily be separate
on the side plenum. Because of the gravitation, the large oil drops
will again flow back to the machine tool through (another) 1/2 inch
oil pipe drain located at the bottom of the side plenum.
3.Final Filtration
The cleaned air is sucked by the blower and blown out through the
"non-woven filter fabrics" towards the top of the unit.
|
 |
|
|
|
NAME of PART |
MATERIAL |
| Blower
Casing |
Aluminum Casting |
|
Impeller |
Aluminum Casting |
|
Inlet Plenum |
Aluminum Casting |
|
Side Plenum |
Aluminum Casting |
| Oil
Seal |
- |
| Motor
Casing |
Steel (1/2 HP) / Aluminum (1, 2 HP) |
| Fan
Cover |
steel |
|
Terminal Box |
steel |
|
Capacitor |
Only
in Single Phase |
|
Bearing |
Ball Bearing |
|
|
